[radvd-devel-l] How do I configure a simple multicast routing?

[Nathan Lutchansky]

-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

On Fri, 14 Oct 2005, Peter wrote:

> I cant find any documentation on how to use radvd.

Probably "man radvd" and "man radvd.conf" are what you're looking for.

> I have on one network interface a potential listener,
> and I want radvd to trigger on the join from there and
> then route a multicast stream that I produce on
> another network interface.

I think you're confused about the purpose of radvd.  It does not perform
any routing, multicast or otherwise, although it is often installed on
systems that perform routing.  radvd sends IPv6 router advertisement
messages which are mostly used configure addresses on IPv6 hosts using the
autonomous address configuration method described in RFC 2461.  -Nathan
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.4.1 (GNU/Linux)

iD8DBQFDUCgYTviDkW8mhycRAm+0AJ42cVIBKc+lxxE6GHAtBRWY82iMcACeOVyD
liFVtPGkWuYzv4MzOaLZVb8=
=n4H/
-----END PGP SIGNATURE-----